Hi,

I have an E-star v3 Dreambox 800SE with built in WIFI. But somehow when i type in my password in the network interface it doesnt connect like it use to do in the old image. I have Blackhole 3.0 installed from jan 2017 (newest from here).

Anyone with the same problem?

thanks in advance!

If you flashed the image, the box will automatically select the RJ45 port.

If you want to set the Wifi, you need to set it as the connection used in the menu of the box.

When you are connected to the box, with telnet or ssh, send the "lsmod" command so we can find out which Wifi drivers is used for your Wifi chipset.

Admin

I have Japhar sim inside NC3 for Dreambox DM800SE

You need to flash this image, and let me know, as the OB3, I don't see it (which one you talk about ?).

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=9023#Post9023

Admin

Systeem OE: OE 2.0
Firmware versie: openbh 2017-02-07 17:24:53. (2016-01-12-(detached from 3915b28))
Kernel versie / stuurprogramma datum: 2.6.18 / 2.6.18-7.4-20101215-r9.0

from the link you provided going to do the telnet

Remember two points,

- The images are published with username "root" and no password (so you press enter/return when it ask for password.

- SSH or WinSCP will never work if there is no password. So you need first to set a password with Telnet to then use the SSH/WinSCP (WinSCP in FTP mode can work as FTP accept no password to login).

But do we talk about the same thing, or you talk about the Wifi Key/password to access your network ?

Admin

Telnet

But do we talk about the same thing, or you talk about the Wifi Key/password to access your network ?

Or you talk about when you access the IP address of your box ?

Try to reflash the box with Bad Sector Recovery and the clean image, as it could have been corrupted. I seen such type of problem (of failure to login to the box with SSH/Telnet) only when the box had an image that was corrupted. A new Flash of clean image should fix the issue, also be sure you have enough Flash space left. Min 1 Mb must be left in the box to have it running smoothly.

Admin

its about the wifi WPA key. Normally i can enter it and it works. It connects. Now it does not.

Check, at what I remember there is 2 options, one is a "password" the other one is a "key". Perhaps you use the wrong one (it's a key and you put it as a password, or vice-versa). There is also various WPA, WPA2 and as well encryption methodes TKIP or AES or Both together.

You can always downgrade to TKIP only or AES only the encryption, try the different combinations.

Admin