Thank you, i will take a look at tomorrow. I wish you all a Happy New year.

Best Regards

bgab39

Here is Picture of the Board back and top

Unfortunately, the images are not clear enough to see the connections.
But check these pins, whether they give an ohm value between the ground, and the measuring point.

If so, it has a good chance that the vu J chip can work on it.
But, on these pins you can not solder wires, they are far too small.
You will have to find another place with some ohm measurements of where these pins go.

Perhaps bgab39 (he is not too far from you) will wish to send you his board, so you can insert the chip/VU J board into it ?

TS

Hi TS!
I am from Norway. Maybe to far? I will try to take a better Picture and post it later, the Pictures has been taken With my phone so it will not be that good.

bgab39

Of course for me no problem but....
Sending/resending/chip cost does not cover the value of the box, it may even become more expensive than buying a new box.

Thank you! I think i will send it to him to be sure that it will be done properly.

bgab39

Pm sent to you with address information.

Cloud-ibox4 by Johnny

I've bought a defective cloud-ibox4 which has the famous red led issue and it was simply to repair by replacing the nand flash chip, but later more about this.

In any case now it works I had the opportunity to see if I could modify it to work with the VuJ chip, and thus removed the old security chip from the print side, added two wires on the Scl/Sda circuits and build a socket for it to easily plugin the VuJ board.

Later I will make a good instructions drawing for it, but for now I can tell that this box perfectly works on the VuJ chip. Uploaded the openpli original duo file, did some online upgrades, tested the card readers etc, and it still works fine. In any case, I have here some pictures from it, have fun..

hi ive a solo2 lorinson and would like to know if VU J chip compatable and where it goes cheers