Hey all,

I have an issue regarding my DV800SEV2 orginal box.
I had by a mistake flashed it with, some firmware, with the SIM info. witch is not required by an orginal box. SÃ¥ the box did show mi this error:

r01: no ca found

I then got japhar dreamup 1.1 - Connected the box, and flashed firmware both from dreammultimedai - and hvad i els found for orginal boxes.. BUT! after a success flashing - i booted the box, and every time it gives me this error:

2ND FAILED!

and it is stuck.. i can flash it again - but same result.

Anybody know how i get my box back up?

thank you !

Try to flash this SSL89 NFI file, it should restore your box to SSL89 and then you can again use it with original SSL89 images. You can flash it with the Official DreamUp, JapharFlasher or OptiFlasher.

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=16897#Post16897

TS

Great mate! thanks... I will try -:)

it did not work...
i flash the 89.nfi - reboot and flash an geniue image... still 2nd failed.

think the box is dead..

but thanks for your time

The box is certainly not dead (it's impossible to break it, it's always recoverable), try to use the software from Yassinov, the OptiFlasher to fix it, and you have the ssl89 that you can flash alone and just reboot it (without flashing any image).

As if you flash an image, we don't know what you flash and this could be the fault... so only the ssl89 or/and optiflasher fixing process.

Admin

optiflasher cost credits.. and the whole credit process i dont understand.. and i am a bit against the whole pay thing..
atleast the version i found...

but again - thnaks everybody for your time

I think that you don't need to pay money for the basics of the software (only for enhanced version functions), so try it and it should be enough to fix your box.

Admin

What Version__ Do we have a download link_ Thanks

See on the forum in the Plugin section,

Link : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=16380

Admin

Dident work.. Cant do anything, when i sele t Advanced and Choose port.. I Press... Do job.. And the program, says No registrition key.. Cant connect using normal.. Have to use port 4..to serial connect..