Hi !
My new Dreambox Two i flashed Dreambox One image.The box started up,but after some restart the box started and up with blue and than blinkeng red.
I have tried uboot "DREAMBOOT" on sdcard but no connection on Putty(serialmode)
Will there be JapharFlasher for this boxes ?

Smokey

Try to flash the box again, press the frontpanel button to have the IP address on the TV screen. Then flash the DreamTwo image.

By mistake I flashed my openpli DreamTwo image on the DreamOne, and naturally it didn't started... I flashed a DreamOne image again and all work ok.

TS

Hi again !

I dont get IP address

Smokey

What do you have on the "Service port" ? Connect the Putty to the COM Port of the USB Cable, at speed 115200 bps.

So we can find out what happens.

TS

Hi again !

I have tried with Putty serial COM5 speed 115200 and sdcard Uboot"DREAMBOOT" but no connection

Tried an DM800se with wrong image and the box logged

Seagen on linux-satellite support have tried to help my with this bud no connection with the Dreambox Two

I think i have to send it back to supplier( Dreambox.no)

Smokey

Which image did you flashed before it failed ?

TS

Dream-Elite 7.0 Dreambox One

Are you sure the COM Port is correct ? As it is different for each box.

TS

Yes Dreambox Two Com5

DM800SE COM3

And you have no communication... zero with Putty ?...

So, yes at this point you should see with the box supplier.

TS

Check on your router the Ip for the box or use the advance IP scanner and see the IP box. Then flash the box with the original dmm image.
P.S. -no need to mention that the LED of the button have to be orange

Hi !
Got a new DreamboxTwo from my supplier some days ago.(warranty)
Have orginal DM image in flash and the new PeterPan in BarryAllen.
Can I install OpenPli 7.3 in BarryAllen or will it only install
DreamOS ?

Smokey

BA doesn't allow Open images, so you can only use with DMM images.

If you want to use OpenPLi/OpenATV/OpenBH, you need to install in Flash and choose which one you want.

Also one thing could be necessary, if the tuners doesn't appear, flash the NewNigma2 image first, boot with it, then flash the Open image, and it should work fine (as the original images update the FP/Microcode of tuner).

TS