Try to see if this happens without any tuner card and antenna connected to the tuner of the box,

Also remove all addons like USB Dongles, HDD, DVD/CD Drive, just to have only the motherboard powered up.

Does it still freezes/reboots after the start is finished ?

Admin

Hi Admin I tried to upload the Image:
Openli 8.5

and everything went fine until configuration!

But I couldn't make the settings properly, because my granddaughter wants to watch TV!

I tried to configure from the display!

Then I rebooted and with the sim inside and with the Eternet cable it stuck in the middle of the display!

Without anything even without the sim3 japhar the message comes out: Error!

I put the sim3 back and it stuck the display bar halfway and halfway!

Reinstall and do the setup properly,

Admin

Hello Admin,

I redid the installation and finally the decoder works and it is possible to see the TV!


But now the fact still remains that it often crashes and sometimes changes the channel again!

But very often it crashes and I have to turn off the decoder to go back to watching TV!

Now I am inexperienced in technical problems I ask you Admin please:

To do a perfect job and make no mistake what is the exact procedure that must be adopted to solve the image block problem!

Before uploading an image you must upload a file of the type:

secondstage-dm8000-84_allsim and after upload the image?

Or is it wrong?

And I always remind you Admin that I always carry out these operations on a: Dreambox 8000 HD Original!


Hi Admin,

and I always thank you for the technical support and for your patience!


Hi Enzo. 57

The SSL is built in the image, so you don't need to flash it before or after the image, as the image already has it inside.

There is sometimes the option of Bad Sector Recovery that could fix problems, you can find details on the topic : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=3137#Post3137

This option above works and needs to be activated, before flashing the image, then you will have to flash the image and it will "clean the Flash memory" checking the bad sectors.

You could also do a Reset of the Bios, sometimes it could fix some issues, the link of the topic is : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=5234#Post5234

If it fails (with a Green Screen), generally you have a log file saved on the HDD that will allow to understand where exactly it failed. The last part/block of the log of it shows the exact issue.

Admin

Good Evening Admin,

I must say that I have solved all these problems that I encountered while programming the two Dreambox 8000!
Thanks to you and who else gave useful tips to understand what to do!

I will take this into account for the next problems I will have!

Anyway now the last piece of the puzzle is this: Can Japhar's NC3 sim be reprogrammed?

I have to try to reprogram it and if I can't then this Sim NC3 is burned!

Good evening everyone and thanks again for the help!

Enzo. 57

The Japhar Sim is reprogrammable, you have all software in the forum, and explanations. It's important to program it for the box you want to use it for, with the Japhar Sim OS for that box. See the smartcard reader section as well as the OS files on the Japhar Box section you want to use it for.

TS