STEP 1. GOTO Main Menu \ Setup \ Search Service \ Tune Press "OK" to "TUNER A" Use the L / R buttons to change the configuration mode to "advanced" Move Down "SATELLITE" Use the L / R Do you select the satellite down to "LNB" Use the L / R to select "LNB 1" Next ensure "DiSEqC mode" is "1.2" (I left the others at the default) lower on "LOF" and set to "Universal LNB" with the L / R Underneath that set "Use USALS" for this satellite "no" with L / R keys Go down to "stored position" Set the location you want for this satellite to appear with L / R buttons ie 001, 002 etc. and press ok then press "OK" to save the information you entered. You must perform this for every satellite position you want to set. Before you positioner installation. STEP 2. GOTO back to the Main Menu \ Setup \ Search Service \ positioner Satfinder Go down to "Satfinder" Press Press ok on Satfinder next image using the L / R buttons to select "Default or Manual transponder", as required Go down to the "Satellite" and use the L / R buttons to select the satellite in postion to put luggage on the button "OK" When you have a block output this screen GOTO back to the Main Menu \ Setup \ Search Service \ positioner installation Press ok configuration positioner image Go up to the next "Tune" Press the "red button" Select the satellite you had a lock, change the transponder so it was the same as in the picture Satfinder Go down to "storage positioner" Use buttons L / R to set the number that postion must be set up, press the GREEN button to save the position once you have saved this place back to satfind and change the satellite to the next one you want to see, when you have a lock on this output satellite again and proceed with the positioner satellite again. You must perform this for every position that seeks to establish, in line with what is done in phase 1

More