how to use enforcer
1) connect dead box to dreamup, press connect
2) press ok at ca error popup, any error just press ok
3) download enforcer
4) drag enfocer in front om dreamup, press enable in enforcer
5)press flash and chose flash file
6) flash probably hangs
7) connect the broken box to dreamup, press connect and try flash, chose flash file, hopefully it works now

--------------------

Originally Posted By: marcin22

1) Connect broken dreambox DM800
2) Open dreamup, press connect.
3) When you see second loader error popup, just press ok.
4) Open file in attachment
5) Drag DM800_repair in front of dreamup, and press dream multimedia logo.
6) Now press the greyed Flash button, and chose firmware.
7) The flash progress will probably hang, its OK.
8) Open dreamup again, connect the broken box, press connect.
9) If all went ok, you can now flash box again, (Use only serial
communication)

when it says file to big. the dreamup didnt detect dm800. This is happen beacuse dreamup is set by default to send old type image. Dm800 has .nfi which is diffrent and bigger. To fix the TOO BIG error, just load the SSL69.NFI boot only using the WEB IP address on Explorer or Firefox.