To me it seems like the entire connector is not soldered correctly.
It appears to have been placed nearly next to the pins.

Is of course to be measured, the connector solder pins should give the same Ohm value as on the D600-D601-D603 diode pins.

And mostly is the measuring red pen (probe) to thick for this job,
I have added a thin needle to it.
_________________________
Doing nothing leads to nothing.

------------- Please note, for technical support -------------
Will be given here, or on the jb8a8f8 forum and I prefer it in English.
Johnny B.

Click on the banner if you like to go there..