Hello guys please help,
My DM900 after switch on remains in rescue mode regardless pushing the stand by button or normal boot.
IP address and Telnet control OK however when I try to open the webIF to flash the box, there is no "Dreambox start page" but this text "Content-Type: text/html;charset=utf-8" appears.
When I try to reflash the firmware I get this:
root@dm900:~# wget
https://dreamboxupdate.com/opendreambox/2.5/stable/images/dm900/zImage-rescue-3.14-r0-dm900-20190911.bin
Connecting to dreamboxupdate.com (82.149.226.170:443)
wget: server returned error: HTTP/1.1 400 Bad Request
root@dm900:~#
I get this bootlog:
,/
,'/___, BOLT v1.18 v1.18 LOCAL BUILD
.'__ ,' (2016-12-01 16:24:31 cynric@cynric-VirtualBox)
/,' Copyright (C) 2016 Broadcom
/'
Board: BCM97252SSFF
SYS_CTRL: product=72521, family=7439b1, strap=000000b2,
otp @ 0xf0404030 = 0x822000e0: en_cr(0x00000060) en_testport(0x00000080) macrovision_disable(0x02000000) moca_disable(0x80000000) rv9_disable(0x00200000)
otp @ 0xf0404034 = 0x00000021: moca2_disable(0x00000001) rfm_disable(0x00000020)
CPU: 2x B15 [420f00f3] 1719 MHz
SCB: 432 MHz
DDR0 @ 1067MHz, DDR1 @ 1067MHz
RESET CAUSE: 0x000001 power_on (1 of 23 possible causes)
CS0: SFDP SPI, 32MB, 64kB blocks, 64kB erase block, 256B pages
EMMC1: transfer complete intr error, intr=0x608000
Command 8 failed
EMMC1: device failed to enter transfer mode
CS1: NAND: unrecognized ID: 0xfefefefe 0xfefefefe
RTS0: 0x1101004, 256 clients, ok
RTS1: 0x1181004, 256 clients, ok
BOX MODE: 5
card if inited
set pwm to 0/255
disp id 5420
load image
AVS: park check
AVS: temperature monitoring enabled
AVS: STB: V=0.890V, T=+52.582C, PV=0.830V, MV=0.890V, FW=30333278 [0.3.2.x]
USB otp=00000040
USB @ 0xf0470200: IPP is active low, IOC is negative polarity
init fp
found card in unknown state
ca valid!
set pwm to 200/255
Normal bootup
Default boot device not found!
Booting failed. Running recovery
Loader:zimg Filesys:raw Dev:flash0.recovery File: Options:(null)
usb: resetting device on bus 0 hub 1 port 1
USB: New high speed device connected to bus 0 hub 1 port 1
usb: found Mass-Storage Device 0951:1607
USBMASS: Unit 0 connected
...........
thanks in advance
Previous Topic
Index
