OE2.2 GP3 images

Are there any Japhar NC3 sim, OE2.2 GP3 images that work on DM800se boxes.
If not can one be coverted/patched to work.

GP3 has stopped since the OE1.6, it looks like to me that it would be necessary to rebuild the GP3 image, but the source code is not available as it happens for OpenPLi etc.

Admin

What about GP3.2 images these are still active on OE2.0
Is it possible to run these on an NC3 japhar SIM.

At what I remember the GP3 is a plugin to install on a "clean" image. So you have to install that plugin on an actual Japhar OE2.0 image to run it hoping it's still compatible in software.

Admin

Can I install a SIM2.1 OE2 GP3.2 image on a DM800SE box using the Japhar NC3 SIM, and will it run OK?

It runs great with the SIM2.1 card with SSL84D.
I would rather use it than the OpenPli based images if it is possible.
The main reason is the Genini GP3 panel Utility it much more useful and user friendly.

The DM800HDse version is Dual, Ferrari + Japhar, only the DM800HD Japhar Sim is Triple (Sim2+Japhar+Ferrari),

So you can use the Ferrari images and the Japhar images you find on the DM800HDse section to try to install the GP3 Plugin.

http://www.ourdreambox.com/ubbthreads.php?ubb=postlist&Board=48&page=1

You can try the PBNIGMA VX 4.2 RC1, and install on it the GP3 Plugin, it could work good and let us know your feedback.

Admin

OK I'll try that out and let you know how it goes.
thanks

I installed the PB image that you suggested.
It was probably on of the worst images I've tried and took an age to boot up.
On first impressions this does look suitable.

Did you tried to install the GP3 Plugin into the OpenPLi 4.0 we published ? Also we are going very soon to publish the OpenBlackHole, would that one suit you better ?

TS

I'm not sure if I tried to install it on the OpenPLi 4.0 previously but I think it was incompatible. Does OpenBlackHole support GP3 ?
I'll try OpenPLi again anyway as I can't remember the result.

Here is some feedback from the OpenPLi forum.
From what is said here it looks like it's not possible.
Have a look at this...

http://forums.openpli.org/topic/32529-gp3-plugin-install-into-openpli-possible/

Try again and let us know, and I hope that it's only question of days, so you can try our new OpenBlackHole,

Admin

Do you like my image DE-OpenBlackHole 1.4 ? Did you tried it with the GP3 Plugin ?

TS