DM800HDseV2.... N3 sim Always goes to Stop

Hi Guy's
I have just installed an N3 chip in my DM800HDSEv2.
I install the second stage AllSim #88j but every image I flash, whether it is via the browser or via Flasher 1.1 it always loads and reports that flash succeded but when I reboot it goes straght to Boot and then Stop.

I have followed the tutorial several times but the result is always the same.

Any idea's ( front button is not stuck) ????

Is there a difference between DM800SEv2 and DM800HDSEv2?

John

There is only 1 box, DM800HDse V2 or DM800se V2, it's the same.

Check your frontpanel button, it may be stuck and pressing the internal switch that blocks the box to Flash Mode.

Admin

Just had a breakthro, I went into the box with Hyperterm and did a factory default.
The box burst into life and is now doing a sat scan with the openatv6.1 image.

Toysoft had already told me about the button sticking but it was not in this case.

Thanks, Regards,

John

Thanks everyone.
It works a treat now.
john

Enjoy ! And have a nice weekend,

Admin