Locked receiver DM800HDse Sim Japhar

Hi all !

As we discussed the other day I have problems with the receiver, I can't turn it on at all. Flash cannot be rewritten in any form.

I tried all possible options, the blue LED stays on and nothing appears on the display. Flash can be rewritten using the Cypres interface ?

If so, what is the procedure ?

Please post the LCD message/image you have, so we can see what could be wrong.

Emosim

Did you tried another PSU ? As generally this type of behavior is because the PSU doesn't give enough Amp... so you could try to disconnect anything (USB and HDD in the box), also remove the Tuner. And try to see if the box boots with the actual PSU and also with a new PSU.

Let us know,

TS

I tried many variants, I used a 12 V - 5 Amp power supply, the same thing.
I took out the tuner, it remained simple pcb.
I'm trying to believe that Flash is out of order.
I'm sending two photos
that's exactly how it stays for a long time.

another time this message appears on my receiver display :

DREAM
BOOT #84J

It doesn't appear all the time

I turn it on and off all the time, now it appears to me exactly as in the photo, without IP.

You need to go thru the NO CA error process with a RJ45 cable and USB Cable to the Service port, please read and do as explained on the Tutorial on link below,

Tutorial : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=15214

To do this job of fixing the box, you need to use JapharFlasher.

JapharFlasher : http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=2012

Admin

Hi all !
I've been trying to fix the receiver for a few days, I tried all the possible options indicated by you, I can't solve anything .
I also changed the power supply, I also changed the service cable, I tried all the possible options . With JapharFlasher v1.1 load only up to " upload completed , waiting for acknowledge... " stay here, don't go any further .
I waited 2 hours, in vain ....
The only option I haven't tried is on the rs232 cable, is this possible on the DM800se ?

Have you set an IP for the JapharFlasher and put the "v" in the box to use the ethernet connection / cable ?

It's necessary if you want the process to finish, you need as it seems to have the USB cable (that looks like working fine), but also the RJ45 cable from the box to the Router/Modem. To have validated the use of the network and be sure that the IP address you use for your DM800HDse box is valid for your network as well as it is not used by another device within your network.

Please check these things, as generally problems are coming from these errors.

Admin

ok , thanks !