dm500hdv2 original

hello everybody.
I have an original dm500hdv2 and after an update to openatv 7.4 the box flashed and had the green LED on but it doesn't start if you disconnect the power the box turns on and the green LED starts blinking and doesn't go away... it doesn't do anything.
Can anyone help I would be very grateful

I would try to flash a new image, press the frontpanel button when you turn it on, you will see it flashing (giving you the IP address, like 192 it's 1 blink, then 9 blinks, then 2 blinks etc)... or you can find out the IP on your router as well.

And flash the latest openpli, that works smoothly,

Link : http://openpli8xstar.japhar.net/OpenPLi8xstar/openpli-enigma2-8xstar-dm500hdv2.nfi

TS

hello. the only way it accepts flash and with dreamup I have already tried several images, it says that it did the flash successfully but in all the images the box does not start, I turn it off at the power supply and turn it back on and the green LED starts flashing, if I pressing turns off the LED but the box does nothing

Connect to the USB service port a USB Cable to your PC with Putty set on the COM port at 115200 bps, to see where it stops in the log that will appear on the Putty console,

TS

Putty doesn't connect

Are you sure of the COM port ?

Did you checked on the Peripherals list ?

Admin

Yes, I checked, I will send a photo as an attachment.

Ok, this confirms it's on COM5,

You should open Putty on that Port at 115200 bps. Then turn on the box and see the log.

Admin

goodnight. Putty doesn't want to connect with a network cable or USB.
Am I doing something wrong?

Yes, why you try to connect in SSH to an IP address 192.168.1.71 ?

You have to connect thru the USB COM cable, from PC to box, with Putty in Serial mode.

Admin

hello. As indicated, it does not connect to Putty.
I'll send you a video to see if you can help me...
I can't put the video here. Is there somewhere I can send it to?
thanks

You connect thru Putty via Network/RJ45,... what is explained is that you need to go thru COM Port cable, which you didn't done. Putty needs to run thru COM / Serial connection / Cable.

TS

I did it just like the previous post and it doesn't connect. I even made a video trying to connect in serial mode and nothing.
where can I put the video ?