Posted by: Admin
DM500S ASIX AX88796LF - Legs Connections on Board - 06/08/15 12:28 AM
DM500S ASIX AX88796LF - Legs Connections on Board ?
You may have a different version, but I do not know better that pin 1 goes to the R74, and R75 to pin 3.
Both go to ground.
(Thank you to Johnny_B for publishing it)
Note: Yellow dots indicate that it is on the other side continues.
Backside is mirrored displayed.
I have a clone DM500s at my bedroom, however the LAN wasn't working a few days ago, so I have checked all capacitors around the ASIX AX88796LF controller, but everything was fine, so it seems the problem was with the ASIX AX88796LF , so I have decided to replace it with a new one, but while I was lifting it up after "re-flow", some of legs went off from the board, I wonder if anyone can give me the connections schematics for ASIX AX88796LF legs on the board, I'll be grateful.
Thanks in advance.
All the best about hardware/support from Johnny_B, link :
http://jb8a8f8.com
http://jb8a8f8.nl
You may have a different version, but I do not know better that pin 1 goes to the R74, and R75 to pin 3.
Both go to ground.
(Thank you to Johnny_B for publishing it)
Note: Yellow dots indicate that it is on the other side continues.
Backside is mirrored displayed.
I have a clone DM500s at my bedroom, however the LAN wasn't working a few days ago, so I have checked all capacitors around the ASIX AX88796LF controller, but everything was fine, so it seems the problem was with the ASIX AX88796LF , so I have decided to replace it with a new one, but while I was lifting it up after "re-flow", some of legs went off from the board, I wonder if anyone can give me the connections schematics for ASIX AX88796LF legs on the board, I'll be grateful.
Thanks in advance.
All the best about hardware/support from Johnny_B, link :
http://jb8a8f8.com
http://jb8a8f8.nl