HELP (No CA Found)

Hi all.

I'll try and keep this short.

I have a DM800 HD SE A8P (Clone) I've been flashing various images into the box over the last week or so without any problems.

I then found that images that I had previously flashed into the box no problem were coming up with the "INVALID" (Or Old Version) message.

I looked at the device information tab on the web interface and noticed that the bootloader version had gone down to an earlier version originally it was version 84

I can't remember the number of the earlier version to which it had changed but after a little homework I thougth that this must be the problem.

I then tried to flash the version 84 bootloader into the box and ended up with the dreaded "R01 NO CA FOUND" message on the front display.

After some messing around I have managed to communicate with the box using Dreamup.

I can get Dreamup to the point were it says "BOX IS NETWORKED IN HTTP MODE" but if I attempt to flash an imagine into the box it just goes to "Calculating Checksum" and stays there.

Please someone tell me that I can recover this box and that I haven't turned it into a doorstop.

Any help and advice would really be very much appreciated.

Thank you and regards, The Soulman.

Maybe these tips helps..
1. Use a wxp system and use dreamup.
2. Connect the box with network and service port.
3. Flash the box with a image file en when done also the boot loader (without turning off the box).
4. Use optiflasher, use repair no ca found.
5. See this image.

Just Flash an image with JapharFlasher, but be sure you flash it with a confirmed A8P image.

Check to be sure you have an A8P sim and not another one...

http://www.ourdreambox.com/ubbthreads.php?ubb=showflat&Number=2679#Post2679

TS

Hi Toysoft.

Sim is definately A8P.

Regards,

Then Flash with JapharFlasher and you MUST have both cables to do this job, USB/ServicePort AND RJ45,

TS

Thank you Toysoft.

Your help and advice is much appreciated.

Please could you give me a "Step by step" novices guide to using the JapharFlasher program and exactly which items I have to flash to get my receiver back up and running.

Thank you and regards, the Soulman.

Check here,

https://www.youtube.com/watch?v=-j8fmt-v1Sg

Admin

Good afternoon all.

Update on "NO CA FOUND"

With the help and advice of the people who have so kindly replied and pointed me in the right direction, and the superb JarpharFlasher software which is available FREE from this very website, I have managed to flash my DM800 HD SE and get it back up and running.

I am SO grateful to all of those of you who replied I really can't thank you enough.

Keep up the good work.

Regards, The Soulman.

;o), enjoy your box that is still the top of today's boxes and it will last for long for sure.

Thank you for updating us that all went smoothly and it's back to life.

TS

https://www.youtube.com/watch?v=F4pI5ESrNsE