DM800HDse A8P image

Hello

Thanks for letting me be part of your forum. Recently I got a DM800HDse with a A8P sim. This box came with a Openld image which is mainly for Europe/ Spain area. I am located in America. I also used my box for Power Vu/ Biss/ Tandberg purposes. Can anyone point me to a good image that I can upload to my box?? Maybe an image with Oscam support already attached to it? Maybe outdated but easy to update. Will appreciated!!

Thanks and Best Regards

The A8P is not a Japhar Sim, so you need to use the images for original boxes, and post on the original box section.

On this section you have a DM800HDseV1 section, where you will find the images compatible with your box.

Original images : http://www.ourdreambox.com/ubbthreads.php?ubb=postlist&Board=105&page=1

If you want to use Japhar images, you will need to swap your old A8P Sim with a Japhar Sim and so have access to Japhar images to load in your box.

Japhar Images : http://www.ourdreambox.com/ubbthreads.php?ubb=postlist&Board=48&page=1


Admin

Thank you very much for your instructions. Feel free to move the post to the original boxes forum. Good Day

Hi all ... !
I also own the DM800se sim A8P receiver .
I want to put a Japhar nc3 sim in it .
please remind me what the procedure is .

thank you in advance !

Hello,

You need first to flash the Japhar SSL84J, then turn off the box, and replace the old A8P sim by the Japhar sim (check to be sure before it's for DM800HDse v1).

This done, you can turn on the box with the new sim in it, and install the image you want from the link below,

DM800HDse V1 Japhar Images : http://www.ourdreambox.com/ubbthreads.php?ubb=postlist&Board=48&page=1

Admin

P.S. : If you need to buy a Japhar sim for DM800HDse, you can find it below, see link : https://jam3.japhar.com/japhar/index.php/product/japhar-dm800se/

Thanks "Admin " !
> receiver is DM800se v1 , is verified .
> sim is japhar nc3 .