Crossepg Openpli4 16th april

I have tried to get crossepg to work on a DM800HD using a flash drive on USB or hard disk on USB.
No matter what I do keep getting 'cannot open database', 'Error opening EPGDB' and 'No valid NIM found'
The saved drive location is XXX /media /usb'
Image is OpenPli 4 16th april. Sim is Japhar multi 3.

Any solution would be appreciated.

Try to use instead /media/hdd for storing data. Is this the built-in version or did you installed it from an external ipk of crossepg ? Do you use the Satellite download or the Rytec internet download ?

Check and be sure you have enough Flash space available to use it. The image is low in Flash, 3 Mb, and it's important to apply the script to clean the flash to get 6 Mb of free flash.

Admin

Thanks for your response.
I flashed OpenPLi_4.0_Japhar_DM800HD_wIPTV_v17.nfi
I did run the memory script right at the start to free up space.I then configured Crossepg using the image installed version.
Memory, out of 60mb there is only 2mb available in root. Other than the script I have not added anything else to the image.
There is no hdd shown in /media only usb - my previous image (blackhole) would mount the usb as hdd.
Can you tell me how to change the usb hdd so that it is mounted as hdd? I suspected this may well be part of the problem. In blackhole crossepg was in /media/hdd whereas it is currently in /usr/crossepg.

Your help is appreciated. Thanks.

Check this post, modifying the fstab file in /etc

http://forums.openpli.org/topic/28588-hdd-mount-instead-of-mediausb/

with



Admin

Thanks again for your help. When I followed this option my USB was reset each time I rebooted and stopped working correctly.

The solution that worked for me is to add the following to the /etc/initd rCS file just type these two lines at the very end of the file
mount /dev/sda1 /media/hdd
mkdir /media/hdd/movie

Then reboot your DM800HD. This is not all my own work but do not recall where I got this from!!!

The second issue is with crossepg when the Configure screen is shown the only option displayed is Red button = cancel and so settings were not being saved (in blackhole the red button is = back that also saves the settings) however the Green button is used in PLi to save and although it is not displayed pressing the GREEN button does actually save the settings.

All is now working great. Very impressed with Japhar Supersim and PLi4 image.

Thanks for your hard work.

Great Job Kdol, and THANK YOU A LOT for sharing your findings that I am sure will help other members as well in future.

Merci,

Admin