Point out the solution to a fault.
The problem appears as "NO CA FOUND" and DreamUp/Sunray-FerrariFiller does not hook.

The cause is the component L800 (as shown) that changes impedance, its original value is 0Ω.

What often shows start problems with a defect on the Y800.

With the L800 is damaged furviante as if you are connected to the USB with Hyper Terminal and watch the boot dell'800SE at any speed baffles the serial always get garbled and we tend to think that Y800 is broken but effects is due all'L800 which should have the same voltage at its ends, however, if value changes from 0 (ohm) to 278 (ohm) there is a reduction in amplitude of the peaks of the clock frequency of the CPU and the result is NO CA FOUND.

(Thank you to Johnny_B for publishing it)

All the best about hardware/support from Johnny_B, link :
http://jb8a8f8.com
http://jb8a8f8.nl