OptiFlasher Pro DMips EDition v3.0.5.0













New Update Features :

-Added Flash Emulator (Universal Flash Mode) Support For SIM2.30 & Japhar SIM
-Added UFM Mode For DM520HD / DM900UHD :
* Now With UFM Mode you can do Universal Flashing for any image using OptiFlasher or Browser :
Result Fully working Image with WebInterface Activated .
-Added SD Card Recovery Mode For DM900UHD/DM920UHD [Advanced Mode]
-Added Kodi installer For DM900 armhf
-Added GP3 Blue Panel Install
-Software Skin Changed
-Software Interface Rebuilded

Download OptiFlasher Pro DMips v3.0.5.0

Very nice !

Mega : https://mega.nz/file/fzokXKZQ#ZqwGRBNCkk9E720WebS_bhuNesCfsZPYlAv-uZDq2OQ

Thank you,

Admin

Eu.Tambem gostei com um olhar,bonito logo inicial.

Agora vou ver na pratica.

Obrigado !

Thanks!!

Thanks!!

#
Hi @YASSINOV.

I have a serious problem with my DM900UHD-4K:
The Box will not start. It has the red Led fixed. The display only shows DreamMultimedia.

I conneted the Box elsewhere; but the problem is the same.

I tried to connect to the Box from my PC: I used DCC and FileZilla, with the last known IP, but without success. I have no IP.

I don't have much experience.
I saw this "OptiFlasher Pro DMips EDition v3.0.5.0" and it's a possibility. But the fundamental point is that I don't have an IP for the Box.

I'm asking for your help.
Thank you very much.
#

Connect a USB Cable to the service port on the back of the receiver, and the other end to your PC with Putty set at the correct COM Port at 115200 bps (Be sure of the COM Port, that you can find on the Computer Hardware details).

This will let you have a log when the box boots, and know exactly the situation, and you will have access to the console of the box, so the internal bootloader, generally it helps to solve all issues.

Admin

#
Hello @YASSINOV

Sorry, I'm a newbie.
I have already installed the PUTTY and connected the USB Cable to the DM900 Service Port.
I started PUTTY.
But I don't know how to do anything else.
What "fields" should I fill in?
Is the Box only turned on after starting PUTTY?

Sorry.
Help me.
Thanks.
#

See screenshot attached,

TS

#
Hello @Toysoft

I started PUTTY.
Insert Serial Line CM13 + Port 115200.
ERROR.

Sorry, I'm a newbie.

Help me please.
Thanks.
#

You have to select the COM Port that is initialized by your box,

TS

Program may be ok but i can't find out .
Been busy half a day , get nowhere ,am busy with satellite stuf for 30 years .
Terrible information , terrible site , you have to be a crypto specialist to get anywhere .
What do i have to do , do i need a key ? where to get ? and how ?
You dont want many users ??
The problem : i have 2 original dm800se v2 boxes , i want to use these with japhar sim .
I have another one with japhar sim wich is ok , but i can't get the others to work
It took me a full week up to now , and my last hope is opti flasher . Then i give up .
For instance : does se800 works with v3.0.5.0 ? where to find that without hours searching ?
How to pay for the key , how to get , stil have not found it , the page the older program

refers to is gone .
Is there a decent pdf manual ? I did not find it .

Sorry i am tyred of searching

Ad