VU+ Uno/Ultimo Tuner - Original and Clone (with V3 chip)

I just f.u.c.k up my VU+ Uno, inserting wrongly the Tuner back to the motherboard, so I put here the photo of how to insert it to be sure nobody else burn their VU+ Uno,

The first line of 2 pin must not be inserted, and then it must be inserted from the 2nd line to the last line of the slot.

Naturally when you update the box to v3.2 security bin, be sure you have the "clone tuner", as the security chip that is beeing updated is on that "clone tuner" ;o).

Concerning the update, it's important to note this :

You MUST use this configuration :

- WinXP
- Laptop
- Real RS232 (NOT USB-Rs232)
- Use the provided Rs232 cable and Rs232 board

Launch the software included on the v3.2 update, load the bin into it, then connect the cable Rs232 from REAL Rs232 port of your WinXP laptop, to the Rs232 board inserted on the back of the Receiver. Then turn on the Receiver. The blue bar should start until the end and show up a box telling the update is successfull.

You could have to retry various times, on my VU+ Duo V3 I had to try at least 15-20 times once, probably some sync problems or ground problems.

Hopefully the original tuner hasn't the problem of putting it wrong compared with the clone one, where do you get the "DUMMY TUNER" ?